6
*Included with select models. Picture/Style may vary from product depending on model.
PRODUCT USAGE
1. Turn the Stand Mixer OFF/0 and unplug.
2. Attach Bowl and Flat Beater, Dough Hook, or Wire Whip* to the mixer. Attach Bowl
and raise into locked position.
3. Place the shield onto the Bowl so that the Motor Head covers the U-shaped gap in
the shield. This will position the pouring chute just to the right of the Attachment Hub
as you face the Mixer. Press lightly so that the tabs snap the shield onto the Bowl.
4. Pour ingredients into the Bowl through the Pouring Chute.
USING THE POURING SHIELD*
DISASSEMBLING THE PRODUCT
1. Turn the Stand Mixer OFF/0 and unplug.
2. Lift the front of the Pouring Shield* clear of the rim of the Bowl. Pull away from the
Stand Mixer. Lower the Bowl and scrape.
PRODUCT USAGE
Electrical Shock Hazard
Plug into an earthed outlet.
Do not remove earth prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these
instructions can result in
death, fire, or electrical shock.
1. Plug the Stand Mixer into an earthed
outlet. Start with lower speed to avoid
splashing and increase it gradually.
Refer to the “Accessory/Speed Guide”.
WARNING
Injury Hazard
Unplug mixer before touching
beaters.
Failure to do so can result in
broken bones, cuts, or bruises.
2. Do not scrape the Bowl while operating.
Scraping the Bowl once or twice during
mixing is usually sufficient.
PRODUCT ASSEMBLY
W11556523B.indb 6W11556523B.indb 6 8/18/2022 11:34:27 AM8/18/2022 11:34:27 AM
To Next Page
Loading...
