12
FAILURE CODES
FF
FF
F
55
55
5 Door signal inconsistent:
• Open and close the door to see if
the oven light responds.
• If the oven light does not operate
properly, replace the door switch.
FF
FF
F
66
66
6* Ambient (console bimetal) sensor
open (too hot):
• Check control bimetal.
FF
FF
F
77
77
7* Control or keypad switches shorted:
• Check continuity of door and latch
switches.
PP
PP
P
FF
FF
F Power Failure:
• Power has been turned on for the
first time, or power has been inter-
rupted.
Temperature Calibration
• Press and hold the BAKE keypad
for 4 seconds. The timer will show
the current setting.
• Press the Bake keypad again to
calibrate the oven temperature.
Each press of the up s or down
t keypad will change the calibra-
tion temperature by 5˚F to a
maximum of ±35˚F.
HIDDEN CODES
To obtain the hidden codes, press and hold each of the following pads for 5 seconds:
BAKE Oven calibration allows bake temperature to be varied ± 35°
BROIL Toggles between Fahrenheit (F) and Celsius (C).
0 Displays the last failure (F/E) code that was used and the latest ROM revision.
1 Shows the type of range the electronic control is configured for.
3 Locks out the keypads so they cannot be used.
6 Switches the range to SABBATH mode.
7 Changes the tone frequency.
FF
FF
F
11
11
1 Control out of calibration:
• Place the sensor in ice water
(32˚F) and check the resistance
(1000 ±20 Ω).
• If the resistance is not within the
specified range, replace the sen-
sor.
• If sensor resistance is okay, re-
place the control module.
FF
FF
F
22
22
2 Keyboard shorted. Cancel not operat-
ing:
• Press the CANCEL keypad.
• Press the BAKE keypad and wait
for 30 seconds.
• If the F2 code remains, replace the
electronic control.
FF
FF
F
33
33
3 Oven probe shorted or open:
• Place the sensor in ice water
(32˚F) and check resistance (1000
±20 Ω).
• If the resistance is not within the
specified range, replace the sen-
sor.
• If sensor resistance is okay, re-
place the control module.
FF
FF
F
44
44
4 Meat probe shorted:
• Make sure the meat probe is
plugged in.
• Check the probe for 5000 Ω at
room temperature and 4000 Ω at
200˚F.
* Not used on some oven controls.
To Next Page
Loading...
