6
PRODUCT USAGE (CONTINUED)
OPERATING THE SPEED CONTROL
WARNING
Electrical Shock Hazard
Plug into an earthed outlet.
Do not remove earth prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death, fire, or
electrical shock.
1.
Plug the Stand Mixer into an earthed outlet. Start with lower speed to avoid splashing and
increase it gradually. Refer to the “Speed Control Guide”.
WARNING
Injury Hazard
Unplug mixer before touching
beaters.
Failure to do so can result in
broken bones, cuts, or bruises.
2.
Do not scrape the Bowl while operating. Scraping the Bowl once or twice during mixing is
usually sufficient.
IMPORTANT: The Stand Mixer may warm up during use. Under heavy loads with extended
mixing time, the top of the unit may become hot. This is normal.
PRODUCT DISASSEMBLY
1. Turn the Stand Mixer to OFF (0) and then unplug.
2. Remove Pouring Shield*: Lift the front of the Pouring Shield* clear of the rim of the bowl.
Pull away from the Stand Mixer.
3. Remove the accessory: Press accessory upward and turn to the left. Pull down the
accessory from Beater Shaft.
4. To remove Bowl: Place Bowl-Lift Lever in the down position. Grasp Bowl Handle and lift
straight up and off Locating Pins.
*Included with select models only. Also available as an optional accessory.
To Next Page
Loading...
