KitchenAid 5KSM7990X - Electrical Requirements; Speed Control Guide

4
PRODUCT SAFETY (CONTINUED)
ELECTRICAL REQUIREMENTS
WARNING
Electrical Shock Hazard
Plug into an earthed outlet.
Do not remove earth prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions
can result in death, fire, or electrical
shock.
Voltage: 220-240 V~
Frequency: 50-60 Hz
Power: 325 W
Recommended operating time:
1-30 minutes with a duty cycle of 10 minutes
ON/15 minutes OFF.
Do not use an extension cord. If the power
supply cord is too short, have a qualified
electrician or service technician install an
outlet near the appliance.
This product is supplied with a Y type power
cord. If the power cord is damaged, it must be
replaced by the manufacturer or a service
agent in order to avoid a hazard.
The acoustic pressure level measured in
conformity with the prEN 454-test code is less
than 70 dBA.
SPEED CONTROL GUIDE
All speeds features Soft Start which allows the Stand Mixer to start at a lower speed to help
avoid ingredient splash-out and “flour puff” at start-up, then increases to the selected speed.
SPEED ACCESSORIES OPERATING TIME ACTION
1 Flat Beater 1-10 minutes
Stirring
2
Flat Beater 1-10 minutes
Slow mixing,
Kneading
Spiral Dough Hook
1-10 minutes
4
Flat Beater 1-10 minutes
Mixing,
Beating
11-Wire Stainless Steel
Elliptical Whip
1-30 minutes
6
Stainless Steel Flat Beater 1-10 minutes
Beating,
Creaming
11-Wire Stainless Steel
Elliptical Whip
1-30 minutes
8–10
11-Wire Stainless Steel
Elliptical Whip
1-30 minutes
Fast beating,
Whipping
NOTE: Use Speed 2 to mix or knead yeast doughs. Use of any other speed creates high
potential for Stand Mixer failure. The PowerKnead Stainless Steel Spiral Dough Hook
efficiently kneads most yeast dough within 4 minutes.