10 | USING THE SIFTER+SCALE ATTACHMENT
ATTACHING THE SIFTER HOUSING TO THE STAND MIXER
Before using your Sifter+Scale for the first time, wipe the ingredient hopper, sifter assembly,
and swivel chute with a warm damp cloth, then wipe clean with a damp cloth. Do not wash the
sifter housing or digital scale. Dry with a soft cloth. See the “Care and cleaning” section for
complete instructions.
1
Turn the Stand Mixer off and unplug.
2
For Stand Mixers with a hinged attachment hub
cover: Flip up to open.
For Stand Mixers with a removable attachment hub
cover: Turn the attachment knob counterclockwise to
remove attachment hub cover.
USING THE SIFTER+SCALE ATTACHMENT
3
Insert the attachment shaft housing into the
attachment hub, making certain the power shaft fits
into the square hub socket. If necessary, rotate the
attachment back and forth. The pin on the attachment
housing will fit into the notch of the hub rim when in
the proper position.
4
Tighten the Stand Mixer attachment hub knob
clockwise until the attachment is completely
secured to the Stand Mixer.
W11221346A - Final.indb 10 22/06/2018 23:33:51
To Next Page
Loading...
