KitchenAid 720-0826 - Gas Conversion; Tools and Parts for Gas Conversion

To Disconnect the 20 lb LP Gas Fuel Tank:
1. Check that the burner control knobs are in the “Off” position
and the grill is cool.
2. Check that the 20 lb LP gas fuel tank is in the “Off” position.
If not, turn the valve clockwise until it stops.
3. Using your hand, turn the gas pressure regulator/hose
assembly counterclockwise to disconnect to the 20 lb LP
gas fuel tank as shown.
Hand loosen only. Use of a wrench could damage the quick
coupling nut.
A
.
Gas
pressure
regulator/hose
assembly
A
B
GAS CONVERSION
Tools and Parts for Gas Conversion
Gather the required tools and parts before starting installation.
Read and follow the instructions provided with any tools listed
here.
Parts supplied
 Natural gas orifices
Parts needed
 Natural gas conversion kit Part Number 710-0003. See
“Assistance” section to order. The conversion kit includes:
 Natural gas regulator 4" W.C. (marked “Natural Gas
Regulator”)
 10 ft (3.0 m) Natural gas hose with quick connector
 5.9" (150 mm) Natural gas regulator hose
 6 mm nut driver
 6 mm wrench
 Hex key
IMPORTANT: Gas conversions must be done by a qualified installer.
Before proceeding with conversion, shut off the gas supply to the
Tools needed
 Phillip screwdriver
 Pipe Wrench
 Adjustable wrench
 6 mm socket and
wrench or 6 mm nut driver
Thin flat-blade screwdriver
 Pliers
 Pipe thread sealant certified
for LP gas
A
.
Gas
pressure
regulator/hose
assembly
B. 20 lb LP gas fuel tank
4. Place dust cap on cylinder valve outlet whenever the cylinder is
not in use. Only install the type of dust cap on the valve outlet that is
provided with the cylinder valve. Other types of caps or plugs may
result in leakage of propane.
Before proceeding with conversion, shut off the gas supply to the
appliance.
18