Hex wrench (for loose
ning control knobs)
5
INSTALLATION REQUIREMENTS
Tools and Parts
Gather the required to
ols and parts before starting installation.
Read and follow the instructions provided with any tools listed
here.
Tools Needed
Parts Sup
plied
■
Gas pressure regula
tor/hose assembly set for 11" WCP LP
gas.
■
1 - “AA” size al
kaline battery
■ 20 lb LP gas fuel tank
tray
■
12 screws (for instal
ling 20 lb LP gas fuel tank tray, 90° clamp/
Natural gas regulator clamp)
■
Hardware packe
t
■ 2 piece 90° clamp (for m
ounting 90° connector)
■
■
Warming rack
Parts Needed
■ 20 lb LP gas fuel tank
Parts Supplied
f
or Conversion to Natural Gas
■
Natural gas conve
rsion kit (which includes):
■ Natural gas regulator (m
arked “Natural Gas Regulator”)
■ 10 ft (3.0 m) PVC flexi
ble gas supply hose with quick
connector
■ 6 mm nut drive
r
■ Natural gas regulator c
lamp
■ 2.05 mm Na
tural gas orifice for rotisserie/infrared burner
Parts Needed fo
r Conversion to Natural Gas
■
G
as
li
ne
sh
ut of
f v
al
ve
■ ½" male pi
pe thread nipple for connection to pressure
regulator.
■ LP gas-resistant p
ipe-joint compound
■ C
SA d
es
i
gn
-ce
rtifi
ed
outdoor flexible stainless steel appliance
connector (4-5 ft [1.2-1.5 m]) or rigid gas supply line as
needed.
Location Requirements
Select a location tha t pro
vides minimum exposure to wind and
traffic paths. The location should be away from strong draft areas.
Do not obstruct flow of combustion and ventilation air.
Clearance to combustible construction for outdoor grills:
A minimum of
24" (58.0 cm) must be maintained between the
front of the grill hood, sides and back of the grill and any
combustible construction.
A 24" (58.0 cm) mi
nimum clearance must also be maintained
below the cooking surface and any combustible construction.
Rotisserie (accesso
ry)*
If you equip your gril l w
ith a rotisserie, a 6" (15.2 cm) minimum
clearance is needed for the rotisserie motor.
A grounded, 3-prong outlet located to the left of the grill is
required.
*See “Assistance or Service” section to order.
■ Tape measure
■
Small, flat -
blade screw driver
■
#2 and #3 Phillips screw driver
■
Level
■
Wrench or pliers
■ Pipe wrench
■
Scissors or cutting plie
rs
(to remove tiedowns)
■ Noncorrosive leak-
detection solution
WARNING
Explosion Hazard
Do not store fuel tank in a garage or indoors.
Do not store grill with fuel tank in a garage or indoors.
F
ailure to follow these instructions can result in death,
explosion, or fire.
WARNING
Fire Hazard
Do not use grill near combustible materials.
Do not store combustible materials near grill.
Doing so can result in death or fire.
To Next Page
Loading...
