KitchenAid KCM1402 - Page 9

4.Placethefiltercartridgeinthewellat
thebottomofthewatertank.Pushthe
cartridgeslightlytomakesureitfitssnugly.
S.Everytimeyouinstallanewfilter,runthe
coffeemakerthroughacompletebrewing
cyclewithoutcoffee.Useafullcarafe
ofclean,coolwater.See"CoffeeMaker
Care"forinformationonwhentochange
thewaterfilter.
ToSet the Time-of-Day Clock for the
First Time or After Power Outage
Electrical Shock Hazard
Plug into a grounded 3 prong
outlet,
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these
instructions can result in death,
fire, or electrical shock.
I. Plug into a grounded 3-prong outlet.
2. When the coffee maker is first plugged
in or when power is restored after an
interruption, the brew timer display will
initially show 12:00 AM, with the hours
section flashing "12". The Clock indicator
wilt flash while the time is being set.
3.
4.
5.
6.
7.
8.
Press the "+" (plus) or "-" (minus)
buttons to increase or decrease the
hours.
Press the SET button. The minutes digits
will flash for the minutes adjustment.
Press the "+" (plus) or "-" (minus)
buttons to increase or decrease the
minutes.
Press the SET button again The AM or
PM indicator wilt flash for the AM/PM
adjustment.
Press the "+" (plus) or "-" (minus)
buttons to select AM or PH.
Press SET button to choose the selected
time. Two short beeps will sound
indicating programming iscomplete.
To Set the Time-of-Day Clock
When the coffee maker isfirst plugged in,
or after a power interruption of more than
one minute, the coffee maker will power
up in the clock setting mode. In this case,
follow the previous directions "To Set the
Time-of-Day Clock for the First Time or
After Power Outage". if adjusting the time
of the clock after initial set up, follow the
complete instructions below.
I. For glass carafe models, press the MENU
button 6 times to enter the Time/Clock
Setting mode. The Clock indicator will
flash while the time is being set.
NOTE: For thermal carafe models, press
the MENU button 5 times to enter the
Time/Clock Setting mode.
2. Press the "+" (plus) or "-" (minus)
buttons to increase or decrease the
hours.
3. Press the SET button. The minutes digits
wilt flash for the minutes adjustment.
4. Press the "+" (plus) or "-" (minus)
buttons to increase or decrease the
minutes.
5. Press the SET button again The AM or
PM indicator will flash for the AM/PM
adjustment.
6. Press the "+" (plus) or "-" (minus)
buttons to select AM or PM.
7. Press SET button to choose the selected
time. Two short beeps will sound
indicating programming is complete.