Installer checkoff
RANGE
[_ Range correctly positioned in
countertop cutout.
[_ Maintained specified distances to
cabinet surfaces.
[_ Range level - front to back - side to
side.
[_ Burner caps positioned properly on
sealed burner bases.
[_AII packing material removed.
[_ Backguard or island trim attached
(see page 3).
[_ Depending on model, grille parts
correctly assembled.
[_ Depending on model, griddle parts
correctly assembled.
GAS SUPPLY
[_The range is connected only to type
of gas for which it is certified for use.
If range
dees net eperate
[_ Check that the circuit breaker is not
tripped or the house fuse blown.
[_] Check that gas valves are turned to
the "ON" position.
[_See Use and Care Guide for
troubleshooting list.
If youneed
The KitchenAid Customer Interaction
Center will answer any questions about
operating or maintaining your range not
covered in the Installation Instructions.
The KitchenAid Customer Interaction
Center is open 24 hours a day, 7 days a
week. Just dial 1o800o422o1230-- the
call is free within the continental United
States, or visit our web site at
www.kitchenaid,com.
When you call, you will need the range
model number and serial number. Both
numbers can be found on the
model/serial rating plate located on the
surface below the control panel.
In the event that your KitchenAid
appliance should need service, call the
dealer from whom you purchased the
appliance or a KitchenAid-designated
service company. A KitchenAid-
designated service company is listed in
the Yellow Pages of your telephone
directory under "Appliances -- Household
-- Major -- Service and Repair."
You can also obtain the service
company's name and number by dialing,
free within the continental United States,
the KitchenAid Customer Interaction
Center telephone number, 1o800o422o
1230. A special operator will tell you the
name of your nearest KitchenAid-
designated service company.
Maintain the quality built into your
KitchenAid appliance -- call a
KitchenAid-designated service company.
If removing the range is necessary for
maintenance, shut off gas supply.
Disconnect the gas and electric supply.
Finish removing the range.
L1
) (
w
(
w
BK
GROUND_It GRN
}K BK
SURFACE BURNER
I/ALIIE
S//VITCHES
GRILLE
VAB/E
SWITCH
GRILLE
//AD/E
120VAC60 Hz
1 PHASE
15OR 20A_,4P
o W
W
: SPARK
L N _:IOD ULE GRILLE
/
GNITOR
_ji- YELsRNOR
j_j_ 4ELCS
:r fSDRFACEBURNER
±±±± ,GN,TOR
.... ELECTRODES
LI
W
BE
GROUND'1t GRN
w
BK
W
_K BK
SURFACEBURNER
VALVE
SW TCHES
I I
L
GRIDDLE
THERMOSTA_
o
GRIDDLE
VALVE
120VACEOHz
1 PHASE
15OR20 AMP
W
W
: SEARK
L N _ODULE GRIDDLE
: IGNITOR
i YELOR
: BRN
i ...... J 4 PLCS
!_'_ --_ _ SURFACE BURNER
±±±2_ GN,TOR
.... ELECTRODES
Cooktop schematic
with grille
Cooktop schematic
with griddle
10
To Next Page
Loading...
