CMD + SHIFT CLICK TO CHANGE COPY
11
English
Finger grip
Drive
adapter
ASSEMBLING THE FOOD PROCESSOR
Installing the reversible shredding disc
TIP: You may need to turn the disc/adapter until it drops down into place.
Installing the multipurpose blade or dough blade
1
Place the blade on the power shaft.
Rotate the blade so it falls into place on
the power shaft.
IMPORTANT: The multipurpose blade and dough blade can only be used with the work bowl.
2
Push to lock: Press down firmly on the
blade until it is down as far as it will go.
3
Install the work bowl cover, being sure
it locks into place.
1
Hold the or reversible shredding disc
by the 2 finger grips with the desired
shredding side facing UP. Insert the disc
adapter into the hole in the bottom of
the disc.
2
With the work bowl installed, slide the
drive adapter onto the power shaft.
TIP: The multipurpose blade features an internal seal that fits tightly over the center of the
work bowl.
W10679565A_v1.indd 11 4/18/14 2:11 PM
To Next Page
Loading...
Need help?
General
