- 14 -
23. Turn the unit right side up and replace the slicing disc sleeve by pressing it onto the motor shaft. Using a towel to help
protect your fingers and press it into place. (Fig. 22)
Fig. 22) Replace Slicing Disc Sleeve
24. Replace the bowl and Lid
25. Test Dielectric and Hi-Pot to check for pinched wires.(Fig. 23) After it passes, Plug the unit in and turn the unit on high
and loosen the bowl and the unit should shut off. Also check the lid the same way to make sure the safety switches
are all working.(Fig. 24)
Fig. 23) Hi-Pot Test Fig. 24) Test Safety Switches
To Next Page
Loading...
Need help?
General
