Countertop opening dimensions that are
shown must be used. Given dimensions
provide required clearances.
Replacement instructions: Use minimum
dimensions given.
Mobile home installation:The installation
of this cooktop must conform to
the Manufactured Home
Construction and Safety
Standards, Title 24 CFR, Part 3280
(formerly the Federal Standard for
Mobile Home Construction and
Safety;Title 24 HUD part 280); or
when such standard is not
applicable, the Standard for
Manufactured Home installations
(Manufactured Home Sites,
Communities and Setups}, ANSi
A225,1 latest edition x_, or with
local codes.
Cuteutdimensiens/requir ents
In Canada, the installation of this
cooktop must conform with the
current standards CAN/CSA-Z240
-- latest edition ___, or with local
codes.
L
See NOTE _ I
for minimum lj
c_earances.
J
Do
not sea_ cooktop
110 COU
24" (61 cm) min.-
deep countertop is
required.
_NOTE: 24" (61 cm) rain. clearance if bottom of wood or
metal cabinet is protected by not less than 1/4" (0.6 cm}
flame retardant millboard covered with not less than No.
28 MSG sheet steel, 0.015" (0.04 cm) stainless steeF, or
0.024"(0.06 cm) aluminum or 0.020" (0.05 cm) copper.
30" (76.2 cm} rnin. clearance between top of cooldng
platform and bottom of unprotected wood or metaF
cabinet.
@
13" (33 cm)
O
\
Gas Fine opening -
Walk anywhere 5" (12.7 cm)
below underside of countertop.
Cabinet floor: anywhere within
6" (15.2 cm) of rear wall is
recommended.
outlet -
Locate within 24"
(61 crn) of right
rear corner of
cutout.
30"
(76,2 cm}
36"
(91,4 cm)
42"
(106.7 cm}
illustration dimensions
@ @ @ @ min.
13-3/4" 19" 16" 2-1/8"
(34.9 cm} (48,3 cm) (38,1 cm) (5,4 cm}
29"
(73.7 cm}
35-1/4"
(89.5 cm)
42_3/4"
(108.6 cm)
19"
(48,3 cm}
19"
(48.3 cm}
19"
(48.3 cm}
36"
(91.4 cm}
42"
(106.7 cm)
2-1/8"
(5.4 cm}
2-1/8"
(B.4 cm)
2-1/8"
(B.4 cm)
: Z7
2-7/8"
(Z3 cm)
2-7/8"
(7.3 cm)
(7.3 cm)
5-5/8"
(14.3 cm)
5-518"
(14t3 cm)
5-5/8"
(14,3 cm)
11-1/2'_
(28.4 cm)
important note on base cabinet construction: After making
the countertop cutout, some installations may require
notching down the base cabinet side wails to clear the
burner box.To avoid this modification, use a base cabinet
having sidewalls wider than the cutout.
NOTE: if cabinet has a drawer, a 4" (10,2 cm} depth clearance from the top of
the countertop to the top of the drawer (or other obstruction} in base cabinet is
required. The drawer depth may need to be shortened to avoid interfering with
the regulator.
To Next Page
Loading...
