PRODUCT INSTALLATION
1. Place Styrofoam packing blocks (2 pieces) on top surface of range/cooktop
Figure 16
2. Place microwave/hood system on top of Styrofoam blocks as shown in
Fig. 16.
3. Thread power supply cord through the hole at the bottom of top cabinet.
4. Using two (2) people,hang the unit on the hooks at the bottom of the mounting plate. Lift unit upward and hold
P- xqsed to the wall.
unit slightly out from the mounting plate.
6. Pull levers down. Press unit to mounting plate. Push levers back up.
16
To Next Page
Loading...
