8
ASSEMBLING THE SPARKLING BEVERAGE MAKER
* The 60 L SodaStream Carbonator produces up to 60 liters of sparkling water, depending
on the level of carbonation.
2
Remove seal and cap from SodaStream
CO
2
Carbonator. Insert 60 L*
SodaStream CO
2
Carbonator into the
Sparkling Beverage Maker. First tip
downward into the base and then
push upward into the valve fitting.
Installing the SodaStream CO
2
Carbonator
Before First Use
Place the Sparkling Beverage Maker on a
flat, sturdy surface, in an upright position.
Remove packaging materials.
The Sparkling Beverage Maker uses 3 AAA
batteries (preinstalled). To replace batteries,
see the “Care and Cleaning” section.
3
Turn the SodaStream CO
2
Carbonator
counterclockwise until it stops.
Hand-tighten only.
4
To reinstall back cover: tilt back cover
toward you; insert bottom tab into slot
and push cover into place.
1
To remove back cover: Grasp back
cover and pull away from unit. Set
cover aside.
To Next Page
Loading...
