KitchenAid KUDS30IVSS4 - Custom Panel Dimensions

To Next Page

To Previous Page

Measureheightofcabinetopeningfromundersideof

countertoptofloorwheredishwasherwillbeinstalled

(youwillneedto measurethelowestpointonthe

undersideofthecountertopandthehighestpointonthe

floor).Referto"DishwasherHeightAdjustmentChart"

forwheelpositionandthenumberofturnsneeded.

opening height position on front leg

33Y8" (8610 cm) Removed All the way Up

I !

34!/4" (87:0 cm) 2 ! 5

NOTE: If the minimum cabinet opening height is less than

34"(86.4 cm), the rear wheels can be removed for

additional clearance. This will allow the dishwasher to fit

into a 337/8.' (86 cm) high cabinet opening, but the

dishwasher will be more difficult to move. (Measurements

are approximate. Wheels and legs are preset at the

factory for 341/2.' [87.6 cm].)

Adjust wheels and legs

)

Turn both leveler legs to the same height. Put wheels in

the required position determined from "Dishwasher

Height Adjustment Chart."

Built-up floors: If the kitchen floor is higher than the

cabinet opening's floor - for example, the kitchen floor tile

does not extend into the cabinet opening - add shims as

needed in the area shown to bring the dishwasher up to

34" (86.4 cm) below the countertop.

NOTE: Shims must be securely attached to floor to avoid

movement when the dishwasher is in use.

nstall the Door Handle

on some models)

Mounting stud

Handle

Setscrew

(in bottom

of handle)

Allen wrench

IMPORTANT: Do not scratch the front panel during this

procedure.

Remove the door handle and hardware bag containing the

setscrews and Allen wrench from the cardboard box.

Setscrews are already installed in the handle. Place handle

on mounting studs with the setscrews facing down. Push

the door handle tightly against the door. Insert the short

end of the Allen wrench into the setscrews. Tighten the

setscrews 1/4turn past snug.

Retain Allen wrench with Installation Instructions.

.....................................................................................................................................................................................................................iiiiiiiiiiii¸I¸ifi_i_iii;ii_iii;iiii;ii_iiiiiii¸iiiii¸iiiii¸iiiii¸iiiiiiiiiii¸iiiiiiii¸iiiiiiii¸iiiiiiii¸iiiii;ii_iii;iiii;iiii;ii_ii¸ii;ii_ii¸ii;ii_ii¸ii;ii_ii¸ii;ii_iii;ii_i;ii_i;ii_i;ii_i;ii_i;ii_i;ii_i;ii_i;ii_i;ii_i;ii_i;ii_i;ii_i;ii_i;ii_i;ii_i;ii_i;ii_i;ii_i;ii_i;ii_i;ii_i

Custom Panel Dimensions