27
5. After cleaning, tilt the grinder
backward so the front of the motor
housing faces upward.
6. With the corkscrew-shaped auger
shaft facing into the motor housing,
insert the burr-shaft assembly into
the grinder. Keep the burr-shaft
assembly level, so the tip of the
auger shaft will line up with the
small socket in the motor housing.
7. Once the burr-shaft assembly is in
the motor housing, rotate the
assembly until it falls into place.
When correctly positioned, the burr-
shaft assembly cannot be rotated.
Continued…
CARE AND CLEANING
To Next Page
Loading...
