4
7
Instructions before use
12.
1. Remove the packaging and check that the ice basket and ice scoop are
inside. If any parts are missing, please contact our customer service.
2. Clean the tank and ice basket.
3. Place the ice cube maker on a level and flat counter top without direct
sunlight and other sources of heat (i.e.: stove, furnace, radiator). Keep at
least 4 inches of space between the back of the product and the wall, and
a minimum distance of 10 cm on each side of the product free.
4. Allow one hour for the refrigerant fluid to settle before plugging the ice
cube maker in.
5. The appliance must be positioned so that the plug is accessible.
6. Fill with potable water only. Only use drinking water.
7. Remove the ice basket to see the water level mark.
Control panel
1 2 4
5
6
3
1
Water indicator
4
Ice size display
2
Ice full indicator
3
Power
5
On/Off
6
Ice size
selection
To Next Page