Kitsound METRO - Call Handling; Playing Music

4 5
Pairing a wireless device
1. Press and hold the MFB (1) to turn headphones on. The LED indicator (7) will ash quickly
blue when headphones are on
2. Turn your iOS, Android, or Windows device’s Bluetooth ON and search for new devices
(check your device’s manual if you’re unsure how to do this)
3. Select ‘METRO’ from the list of found devices
4. If asked for a passcode, enter ‘0000’ or ‘1234’ and the headphones will then be connected
to your device
5. After pairing successfully, the LED indicator (7) will ash blue occasionally; you can then
answer the phone or listen to your music
6. The next time the headphones are switched on, they will automatically search for and
attempt to connect to the last paired device
Note: ‘Bluetooth’ is a trademark of Bluetooth SIG, Inc. This product is in no way aliated with
or endorsed by Bluetooth SIG Inc.
Re-pairing or pairing new devices
1. Make sure the wireless connectivity is turned o on any previously paired devices
2. Follow the ‘Pairing a wireless device’ instructions from step 1
Call-handling
Answer a call Press the MFB (1) to answer. During the call you can increase
the volume by using the Volume+ (5) and Volume– (2) buttons
on the headset
End call During a call, press the MFB (1) to end call
Playing music
Play/Pause Press (don’t hold) the MFB (1) to switch between play and
pause status
Adjusting the volume Hold the Volume+ (5) and Volume– (2) buttons to control the
volume. The volume can also be adjusted on your device
Music selection Press (don’t hold) the Previous track (2) or Next track (5)
buttons to switch songs