Kitsound MyJack2 - Instructions for Use; Charging the MyJack2; Getting Started; Pairing to a Wireless Device

4 5
Pairing to a wireless device
1. Once turned on, the MyJack2 will automatically enter pairing mode, and the LED
indicator (2) will ash blue
2. Turn your iOS, Android, or Windows device’s Bluetooth ON and search for new devices
3. Select ‘KS MyJack 2’ from the list of found devices
4. If asked for a passcode, enter ‘0000’, and the MyJack2 will be connected to your device
5. After pairing successfully, the LED indicator (2) will be solid blue
Note: ‘Bluetooth’ is a trademark of Bluetooth SIG, Inc. This product is in no way aliated
with or endorsed by Bluetooth SIG Inc.
Note: The MyJack2 will slowly ash blue after 5 minutes, if no connection is made to a device.
Re-pairing or pairing new devices
1. Turn wireless connectivity o on any previously paired devices
2. Follow the ‘Pairing to a wireless device’ instructions
OR
Instructions for use
Charging the MyJack2
Give the MyJack2 a full charge before its rst use.
1. Connect the Micro USB charge cable to the Micro USB charging port (3) and plug into
a power source
2. The LED indicator (2) will be solid blue whilst charging which may take up to 2 hours
3. Once fully charged the LED indicator (2) will turn o
Note: Please allow up to 2.5 hours for the rst charge.
Getting started
• To turn the MyJack2 on, press and hold the MFB (1) for 5 seconds
• To turn the MyJack2 o, press and hold the MFB (1) for 7 seconds
Note: The MyJack2 will shut down automatically after 15 minutes of no activity.
[continued...]