Kitsound XDOCK2 - Basic Operation; Setting the Clock; Alarm Functions; Snooze and Alarm Management

10 11
Alarm 2
• Put the XDock2 into standby mode
• Press (don’t hold) the ‘Vol+‘ (4) button and the Alarm 2 icon will flash
• Press the ‘Up’ (6) or ‘Down’ (5) buttons to select between buzzer, iPod or radio to wake you up, followed by the
‘Vol+‘ (4) to confirm
• Press the ‘Up’ (6) or ‘Down’ (5) buttons to change the hours, followed by the ‘Vol+‘ (4) to confirm
• Press the ‘Up’ (6) or ‘Down’ (5) buttons to change the minutes, followed by the ‘Vol+‘ (4) to confirm
• The alarm is now set
Snooze
Press the ‘Shhhh!’ (7) button. The alarm will then go off and will resume again in nine minutes.
NOTE: The alarm will repeat every day until it is reset.
If you have selected to be woken up with your iPod/iPhone but have not docked it, you will be woken with the buzzer.
In order to wake to your iPhone or iPod, it must be docked and powered off. If it is in the play mode, no alarm will
sound. If your iPhone or iPod has less than one hour of songs, put it in repeat mode.
Turn off the alarm
• Press the Power/Mode (1) button
Cancel the alarm(s) you have set
With the XDock2 in standby mode, press the Vol– (3) / Vol+ (4) button until the desired alarm icon does not show on
the LCD display.
Basic use
Turn the XDock2 on
• Firstly, make sure the AC adapter is connected and that the main power switch on the rear of the unit is in the
‘ON’ position
• Now press and release the ‘Power/Mode’ (1) button
NOTE: Pressing this button again will cycle through the Aux/iPod/iPhone and Radio modes (explained later)
Put the XDock2 into standby mode
• Press and hold the Power/Mode (1) button until the display dims
Set the clock
Simply dock your iPod or iPhone and the XDock2 will automatically adopt the exact same time. Alternatively:
• With the XDock2 in standby mode, press and release the ‘Menu’ (2) button. The hour digit will now be flashing
• Press the ‘Down’ (5) or ‘Up’ (6) button to decrease or increase the hours and press the ‘Menu’ (2) button to confirm
your setting. The minute digits will now be flashing. Press the ‘Down’ (5) or ‘Up’ (6) button to decrease or increase
the minutes and either press the ‘Menu’ (2) button or wait for a few seconds to save the time
Alarm1
• Put the XDock2 into standby mode
• Press (don’t hold) the ‘Vol-‘ (3) button and the Alarm 1 icon will flash
• Press the ‘Up’ (6) or ‘Down’ (5) buttons to select between buzzer, iPod or radio to wake you up, followed by the
‘Vol-‘ (3) to confirm
• Press the ‘Up’ (6) or ‘Down’ (5) buttons to change the hours, followed by the ‘Vol-‘ (3) to confirm
• Press the ‘Up’ (6) or ‘Down’ (5) buttons to change the minutes, followed by the ‘Vol-‘ (3) to confirm
• The alarm is now set