3 Person Full Spectrum Sauna Only
• Have a certied electrician install a dedicated outlet for the sauna. Failure
to do so will affect the operating performance of the sauna.
General
• Before connecting the sauna to a power source, please ensure all the
wires, cords and connections are properly connected.
• Plug the sauna into a proper wall power outlet. Do not share the same
outlet with any other appliances.
• Install the sauna on a completely level surface and in an area that is dry
and protected from the weather.
• WARNING: To reduce the risk of electrocution and burns, do not operate
unless the heater guard is correctly in place.
• CAUTION: Do not place combustible materials on or against heaters at
any time.
• To reduce the risk of electric shock and/or re, do not expose the control
system to water or rain. Do not open the cover to the control system as
there are high tension ttings that can be dangerous. Only authorised
and approved technicians should make any necessary repairs.
• Any unauthorised repairs, alterations or modications can lead to
serious injury and can cause the sauna to operate outside its intended
specication parameters which will void the warranty.
• WARNING: Reduce the risk of electrocution by disconnecting the power
supply before servicing.
• Do not spray the exterior with water. If the area you are installing the
sauna has a tendency for dampness, place rubber matting or other
suitable barriers underneath the sauna.
• Keep all liquids away from the heating panels and electronics.
• Keep ammable objects and corrosive chemical substances away from
the sauna.
• To prevent burns or electrical shock, do not touch or use metal tools
on the infrared heating elements or the net cover of the far-infrared
heating elements.
Installation Requirements
To Next Page
Loading...