This process is easiest with at least 2 adults working together.
Structural Creation
1. Start with the bottom panel. Place it in your desired location and ensure the front part of
the panel is placed in the correct direction.
2. Assemble the back panel by aligning the back panel with the corresponding battens on the
bottom panel making sure they are in the same line. One person should hold the back panel
while the other person continues to the next step.
3. Align the left panel with the bottom panel and the corresponding battens. There are 3 male
buckles attached to the side of the back panel. Align these with the female attachments on
the left panel and ensure all 3 are tightly secured locking the left and back panels together.
4. Repeat the last action with the right panel. If done correctly the 3 sides will form a solid
bond.
5. Repeat action 3 with the front glass panel. Do not cut the tie in the door until the glass
panel is securely in place. Then you can cut the safety ribbon.
6. Now assemble the seat. Start with the heating panel that sits upright, sliding this into place
using the exposed screws in each side wall as a guide, if done correctly this panel should
stand alone without the need to hold it. Then assemble the seating supports into place before
sliding the seat on top of them. Your seat should be rm and not be unstable when sitting.
7. Now you can connect your door handle. Using a larger Phillips head screwdriver, ensure
that the wooden handle is on the inside.
8. Attach your heating panels on the inside of the xed front glass. You will nd 2 holes ready
for you to attach your heaters in place. Once attached these are plugged in, inside your sauna.
9. Remove the dust cover from the ceiling component to expose the wires underneath, then
slide on your ceiling into place and match up each wire tting with its correctly labelled
partner. ie Plug A from the control box matches up with Plug A from the Sauna Wall. Then
reattach Dust cover.
10. If done correctly you will be able to switch on your sauna once it is plugged in.
Electrical Connection
1. Put any wires from the front and back panels back into the centre of the sauna cabinet
to avoid pressing them when installing the internal top panel.
2. Connect all the wires and connectors to the corresponding outlets on the internal top
panel. Make sure connections are tight and secure.
3. The last step is to secure the external top panel over the internal top panel. Align the
top panel and secure it with the screws supplied.
4.Installation should now be complete. Plug in the power and turn the sauna on at the
control panel.
Installation Process
To Next Page
Loading...