Sauna
PAGE 8
50701162/12.12
9. If something does not work
All repair and maintenance work must be done exclusively by Klafs or by a dealer we
expressly authorize!
Error Cause Remedy
The control
system cannot be
switched On.
No operating voltage
available.
Check the FI-switch and the fuse in the mains
supply.
Fuse SI102 or SI104
triggered.
Replace fuse SI102 (1.6 AT) or
SI104 (1.0 AT) or contact Klafs Service.
The controller
cannot be started
up in standby
mode.
The safety temperature limiter
(STL) tripped.
Do not operate the control system.
Inform Klafs Service.
The cabin light
does not turn On.
Light bulb defective. Change the light bulb.
Procedure: separate the control system from
mains.
Replace with a light bulb of the same
wattage.
No operating voltage
available.
Check the FI-switch and the fuse in the mains
supply.
Fuse SI103 light triggered. Replace fuse SI103 light (0.6 AT) or contact
Klafs Service.
10. Maintenance and Cleaning
10.1. Cleaning the sauna cabin
The humidity level in SAUNA mode does not harm the wood of your cubicle. Without fail, the cabin
must be aired out properly.
Never hose down inner cabin walls, bench or seats with water or a high pressure
cleaner!
Dirty benches
Wipe the wooden surfaces with a damp cloth.
If necessary, sand the surface of the benches with fine sandpaper.
The benches can also be washed off with a 3 %- hydrogen peroxide solution (available in
specialized stores).
Disinfectants are highly corrosive!
Therefore, pay attention to the relevant safety regulations!
Use household rubber gloves!
The outer cabin walls are impregnated or glazed.
In no case glaze, paint or impregnate the inner panelling or the cabin inner walls and
units (benches etc.).
To Next Page
Loading...