39
12 SLEEP
Press this button under cooling, heating mode can start up sleep function. The
icon will be displayed on
remote controller. Press this button again to cancel sleep function. The icon on remote control will not
be displayed any more.
13 LIGHT
Press this button can turn off the light for indoor unit’s display: The
icon on remote control will disappear.
Press this button again to turn on the light for indoor unit’s display. The icon on remote control will be
displayed.
Key combinations
Child lock function
Pressing „+“ and „-“ buttons simultaneously can turn on or turn off the child lock function. When the child
lock function is started up,the
icon will be displayed on the remote control. If you operate the remote
control the icon will flash three times while the remote will not send any signal.
Operation
1. After putting through the power, press ON/OFF button on remote control to turn on the air conditioner.
2. Press the "MODE "button to select your required mode: AUTO, COOL, DRY, FAN, HEAT.
3. Press the "+" or "-" button to set your required temperature. (Temperature can’t be adjusted under auto
mode).
4. Press the "FAN" button to set your required fan speed: auto, low, medium and high speed.
5. Press the
and buttons to select fan blowing angle.
Replacement of batteries in remote control
1. Press the back side of remote control and then push out the cover
of the battery box along the arrow direction.
2. Replace two 7# (AAA 1.5V) dry batteries, and make sure the
position of "+" polar and "-" polar are correct.
3. Reinstall the cover of battery box.
Note:
• During operation, point the remote control signal sender at the receiving window on indoor unit.
• The distance between signal sender and receiving window should be no more than 8m, and there should
be no obstacles between them.
• Signal may be interfered easily in the room where there is a fluorescent lamp or wireless telephone; re-
mote control should be close to indoor unit during operation.
To Next Page
Loading...
