Klarstein 10029708 - Page 52

52
Step 8: bind up pipe
1. Bind up the connection pipe, power cord and drain hose with the band.
indoor unit
gas
pipe
indoor and
outdoor power cord
liquid pipe
drain hose
band
drain hose
band
connection pipe
indoor power cord
2. Reserve a certain length of drain hose and
power cord for installation when binding
them. When binding to a certain degree,
separate the indoor power and then separate
the drain hose.
3. Bind them evenly.
4. The liquid pipe and gas pipe should be bound
separately at the end.
Notes:
• The power cord and control wire can't be crossed or winding.
• The drain hose should be bound at the bottom..