15
EN
2 3
After the base is put on the fan body, follow the schematic
to secure the power cord under the base clip, then tighten
the screws.
Hold the clip and
forcibly pull the
base out, after the
clip comes out, use
the same method to
remove another clip.
USE AND OPERATION
Operate using a remote control (each button on the remote control is the same as
that of an actual fan):
On/Off
• When this button is pushed, the fan will start at a low speed.
• By pressing this button again, the fan will stop working.
Fan body
Basie
Fixing
screw
Power cord
To Next Page
Loading...
