28
EN
from the outside to remove the EVA lter screen frame. Unscrew four screws xing
the EVA lter screen and the rear housing to remove the EVA lter screen (as shown
in the above gure) .
2. Put the EVA lter screen into warm water with neutral detergent (about 40 °C /
104°F) and dry it in the shade after rinsing clean.
Unit Storage
1. Unscrew the drainage cover, unplug the water plug, and discharge the water in the
water pan into other water containers or directly tilt the body to discharge the water
into other containers.
2. Turn on the machine, adjust it to low-wind ventilation mode, and maintain this state
until the drainage pipe becomes dry, so as to keep the inside of the body in a dry
state and prevent it from mildewing.
3. Turn off the machine, unplug the power plug, and wrap the power cord around the
wrapping post; install the water plug and the drainage cover.
4. Remove the exhaust pipe and keep it properly.
5. Cover the air conditioning with a plastic bag. Put the air conditioning in a dry place,
keep it out of the reach of children, and take dust control measures.
6. Remove batteries of the remote control and keep them properly.
Note: ensure that the body is placed in a dry place and keep all machine components
properly.
To Next Page
Loading...
