31
EN
The sealants with code No. 22 need to be removed off the marking ring from the sealant
and pierce the keg by cooler piercing pin.
The difference between code No. 23 and 24 is the safety clasp quantity. Pull up the
(like code No. 20 sealant) provided in the beer cooler, attach it to the beer keg, and
pierce it by cooler piercing pin.
Note: Before replacing the sealants or piercing the cooler kit, you must always follow
the instructions marked on the keg to eliminate the excess gas and ensure that the keg
has rested long enough to avoid foam coming out through the cooler piercing pin /
tap faucet. And it is no need to release the gas and replace the seal rubber if you
use a keg with an integrated pressure cartridge. Because it has its own CO
2
pressure
inside, there is no need to provide it from an outer CO
2
pressure system.
To Next Page
Loading...
