Klarstein 10033689 - Troubleshooting Guide; Tap Issues: No Beer or Pouring Problems; Foam, Temperature, and Pressure Issues

45
EN
TROUBLESHOOTING
Note: If the beer cooler does not work properly, please call the service centre. To
save time and money, before you call for service, check the Troubleshooting Guide. It
lists cause of minor operation problems that you can correct yourself.
Problem Possible Cause Suggested Solution
The tap does not work /
can’t pour beer out.
1. The pouring tube is in
poor connection or CO
2
supplying is cut off
1. Well connect the
pouring tube and CO
2
supplying.
2. No keg or no beer in
the keg.
2. Change a new keg.
3. No gas in the CO
2
cartridge.
3. Change a new CO
2
cartridge.
4. The CO
2
pressure
regulator knob is closed.
4. Turn the CO
2
pressure
regulator knob on “+”
position.
Too much bubble pouring
out.
1. Use a wrong way to
pour beer out.
1. Quickly open the faucet
completely.

correct distance from the
beer mug to the tap when
pouring wine. Normally
to the height, the normal
foam should be thick and
creamy.
2. The beer temp is high
(better at 3-5 °C.
2. Cool the beer down to
3-5 °C.
3. The keg is shaken
before usage.
3. Put the beer keg aside a
while till no bubble inside.
4. Almost no beer in the
keg.
4. Change a new keg.
5. Too much pressure in
the keg.
5. Adjust the pressure
knob to “-“ direction to
decrease the pressure or
close the knob.