Klarstein 10033689 - Replacing the CO₂ Cartridge

39
EN
Change a new CO
2
cartridge (no need for keg)
Please change the CO
2
cartridge if cannot pour beer out when the CO
2
pressure knob is
at “on” position and has beer in keg.
1. When turn the CO
2
pressure knob to “-“ position, to close the CO
2
supplying.
2. Open the lid, loose the cartridge sheath, and take out the empty CO
2
cartridge.
Insert a new CO
2
cartridge in the sheath, and screw the sheath tightly until you will
hear a “Click”, which indicates that the cartridge seal has been pierced and the
CO
2

avoid the CO
2
leakage. Then put CO
2
bottle sheath into the lid.
3. Close the lid of the beer cooler.
4. Turn the CO
2
pressure knob to “+“ position to turn on the CO
2
supply, and it is
ready to pour beer out.
Note: If used correctly, one CO
2

case of problems with the pressure regulator, refer to the “Troubleshooting” section.
WARNING

2
cartridge. The below
CO
2
cartridge information for your reference. Never use nitrogen gas
cartridge in the beer cooler to avoid the explosion, because of its much
higher pressure.
CAUTION
Risk of injury! New CO
2
cartridges must be stored safely. Make sure
that children do not play with them.
16g CO
2
cartridge