EasyManua.ls Logo

Klarstein 10034662 - Page 35

Klarstein 10034662
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
35
EN
Notes on the use of the window kit
The window kit is only designed to be installed with sliding or sash windows
or doors. The window kit is not designed or to be used with any other style of
windows.
The sh tail adaptor can be used without the slide bar with most windows / doors.
When using the air conditioner ensure that the opening left around the shtail is as
small as possible as the cooling will be less efcient.
The best form of installation is through a wall duct. By properly venting you expel
hot air from your room while efciently cooling it.
Your air conditioner should be used without the vent pipe in dehumidier mode.
When using dehumidier mode ensure that an external water tank is used,
monitored and regularly emptied before overowing. Permanent plumbing can be
also installed for dehumidier mode or an external uplift water pump can be set up
for unattended use. The outlet vent must be well ventilated and not obstructed as this
will cause the unit to overheat. Avoid bending the air hose more than 30 degrees
(see below gures).
M
B
A

Table of Contents

Related product manuals