29
EN
Insert lter
When you have cleaned the lters, replace them in reverse order. Make sure that the
lters are rmly seated.
Clean air inlet lter
Clean the air inlet lter once a month. Remove the lter by holding the lower and
upper ends of the frame and pulling it out. Clean the inlet lter with a soft brush. Then
replace the lter in the frame and secure the frame.
Cleaning of the inner and outer surface
• Do not clean the device with running water.
• Do not use solvents, thinners or alcohol for cleaning.
• Clean the drum only with a damp cloth, do not use spray cleaners. Clean the drum
before each use.
• Do not use scouring agents or abrasive sponges for cleaning, they will damage the
surface of the unit.
lter frame
Inlet lter
To Next Page
Loading...
