Klarstein Le Vide - Loss of Vacuum After Sealing; Improper Pouch Sealing; Error Codes

29
EN
Vacuum pouch loses vacuum after being sealed
• Sharp items can puncture small holes in pouches. To prevent this, cover sharp edges
with paper towel and vacuum in a new pouch.
• Some fruits and vegetables can release gases (out-gassing) if not properly
blanched or frozen before packaging. Open the pouch; if you think the food has
spoiled, discard the food. If the food not yet spoiled, consume immediately. If in
doubt, discard the food.
The vacuum sealer is not sealing pouch properly
• Seal time may not be long enough. Increase seal time and try again.
• Pouches will not seal if any moisture, food particles or debris are present in the seal
area. Wipe the inside of the pouch clean and try again.
• The pouch must be properly placed along the seal bar. Make sure the entire pouch
is over the seal bar and there are no wrinkles in the pouch material.
ERROR CODES
Code Possible Cause Suggested Solution
E01
When the machine has not
vacuumed for some time, the two
pressure switches do not close.
Check if the vacuum lid is closed;
Check if the sealing gaskets are
assembled correctly;
Check if the pump still works;
Check if the pressure switches
are still functioning (check the
connecting pipe, pressure switches,
10P data cable, etc.)