33
EN
INSERTING A NEW BEER KEG
When the beer in the keg runs out, before changing a new beer keg:
1. Adjust the CO₂ pressure regulation knob to “-“ switch to shut off the CO₂ supplying
and save the CO₂.
2. Open the top cover of the beer cooler, pull down the tap handle to release the rest
gas in the keg (maybe with some beer bubble).
3. Then put the piercing pin into the new keg and put into the beer cooler. Connect the
gas-tube and beer tube from the keg lifter, by pressing the white parts of keg lifter.
4. Disconnect the gas-tube and beer tube from the keg lifter,
5. Take out the keg by the keg lifter, and pull out the piercing pin from the keg.
6. It is recommended to clean the tap mechanism when changing the beer keg each
time. Please refer to the below contents about cleaning.
When you take out the fastener of beer dispensing
unit, you can move this unit towards arrow
indication.
When you take out the beer
connector and CO₂ connector,
please press the white button down.
You must take out
the right fastener at
rst, then push the
left fastener out as
arrow indication,
you can pull out
the dispensing unit
nally.
To Next Page
Loading...
