34
EN
INSERTING A NEW CO
2
CARTRIDGE
Note: not required for Heineken kegs!
Please change the CO₂ cartridge if can’t pour beer out when the CO₂ pressure knob is
at “on” position and has beer in keg.
1. When turn the CO₂ pressure knob to “-“ position, to close the CO₂ supplying.
2. Open the top cover, loose the cartridge sheath, and take out the empty CO₂
cartridge. Insert a new 16g CO₂ cartridge in the sheath, and screw the sheath
tightly until you will hear a “Click”, which indicates that the cartridge seal has been
pierced and the CO₂ gas can ow into the keg freely. Make us the bottle sheath
is xed tightly to avoid the CO₂ leakage. Then put CO₂ bottle sheath into the top
cover.
3. Close the top cover of beer cooler.
4. Turn the CO₂ pressure knob to “+“ position to turn on the CO₂ supply, and it is
ready to pour beer out.
Note: Each 16 g CO₂ cartridge can pressure more than 5 L beer out.
Safety instructions:
• Please use the qualied CO₂ cartridge. The below CO₂ cartridge information for
your reference. Never use Nitrogen gas cartridge in the beer cooler to avoid the
explosion, because of its much higher pressure;
• New CO₂ cartridge need good reserve, any play if forbidden, or will cause
hazards.
Net weight 15,5-16,5 g B 88-89 mm
Volume 20 ml C 21,7-22 mm
Gross weight 57-58,6 g D 19-11 mm
Cartridge weight 42-42,6 g Pressure 60 kgf/cm2
A 8,6-8,9 mm Detonation pressure 45 bar
To Next Page
Loading...
