Klarstein Skypillar - Troubleshooting

17
EN
Humidication/cooling button: Pressing this button starts the function. If you
add ice, the temperature will be lowered even faster. Press the button again to
cancel the function.
Note: Never use this function when the water tank is empty or the water level
is below the minimum mark.
Timer: The timer cycle is: 2 hours - 4 hours - 8 hours - 12 hours. The maximum
timer setting is 12 hours. Press the button again to cancel the function.
Otherwise, the appliance will automatically switch off when the set time has
elapsed.
TROUBLESHOOTING
Problem Possible cause Suggested solution
The device is not running. The plug has not been
plugged in correctly.
Insert the plug rmly into
the socket.
The nebuliser unit has not
been installed correctly.
Install the nebuliser unit
correctly.
The unit is switched off. Switch on the unit.
The wiring in the unit has
come loose.
Contact a specialist
company for repair.
Air humidication does not
work / The pump makes
strange noises.
No water in the water tank
or the water level is below
the MIN mark.
Switch off the unit and ll
the water tank with water.
The lter sieve of the
submersible pump is
blocked.
Clean the lter sieve.
The water outlet hole of the
nebuliser unit is blocked.
Clean the nebuliser unit.
The pump or the wiring in
the unit has come loose.
Contact a specialist
company for repair.