34
EN
• You can touch SET mark to set the internal temperature for each zone. The degrees
indicators will appear in the display window marked for UPPER ZONE and
for LOWER ZONE.
• When you touch the SET mark for the rst time the LED readouts will show the
original temperature sets previously (the preset temperature at the factory for UPPER
ZONE is 10ºC / 50ºF and for LOWER ZONE is 16ºC / 60ºF).
• Touch the SET mark once. The left LED indicator for UPPER ZONE will ash. Then
touch the UP or DOWN marks to set the desired temperature.
• When you touch the SET mark again, the right LED indicator for LOWER ZONE will
ash. Then proceed to touch the UP or DOWN marks to set the desired temperature
for the LOWER ZONE.
• The temperature will increase 1°C or 1ºF if you touch the UP mark once, or the
temperature will decrease 1°C or 1ºF if you touch the DOWN mark once.
• The appliance is designed to display the set temperature. To display the current
temperature, press the UP button for 5 seconds. After another 5 seconds, the set
temperature is displayed again.
Temperature Display
During normal operation, the temperature display on the control panel shows the
temperature inside the appliance. The temperature display will ash if:
• A different temperature is being set.
• The temperature in the zone deviates by more than 5 °C from the set temperature.
The temperature display ashing ensures that the temperature can not rise or fall
un-noticed and impair the wine.
To Next Page
Loading...
