13
14. How to set and cancel the rocker potentiometer
Set the rocker potentiometer settings: Press [RUN/EDIT], to light the indicating
light, and then press [SET X/Y] immediately; according to the prompt on the LCD,
select two scanning channels corresponding to the scanner X and Y direction from
(P1-P8) (or from PCH9-PCH16 by pressing SHIFT), shift to use the rocker
potentiometer to control the green indicating light, and the light is on immediately.
In case of wrong input, press [DELETE] to cancel the input, and input the correct
corresponding channel, and then press [SET X/Y] again to memorize it and quit.
Cancel rocker potentiometer settings: In the state of [SET X/Y], press
[DELETE] to clear the input data, and the green indicating light turns off
immediately; and then press [SET X/Y] again to memorize it and quit.
15. Conventional dimmer control
Point control: Press P13-P24 to control the dimmer 206-217 channels, and when the
indicating light is on, the output is 100%, and when the indicating light is off, the
outputs is 0%.
Distributed control: In the state of non-programming, press SCAN/LIGHT to make
the indicating light turn on; enter the dimmer state, select the channel page of
dimmer control by pressing SA/SB/SC, and push the different sliders in the slider
area to adjust the dimmer output.
To Previous Page
Loading...