16
USING THE LINE SPLITTER (FIG. 2)
1. Plug Line Splitter 10x into receptacle.
2. Plug the load (appliance or device) into the line splitter.
3. Measure current by clamping the clamp meter around the Line
Splitter 10x.
4. The current measured by the clamp meter is 10x the actual current
present in the circuit.
ENGLISH
CLEANING
Wipe with a clean, dry lint-free cloth.
Do not use abrasive
cleaners or solvents.
Test Equipment Depot - 800.517.8431 - 5 Commonwealth Ave, Woburn, MA 01801
TestEquipmentDepot.com
To Previous Page
Loading...
