Klein Tools ET50 - ET50 GFCI Testing Procedure; ET50 Battery Replacement

ENGLISH
GFCI Testing
Check the GFCI Receptacle user manual for more information.
Check the GFCI Receptacle user manual for more information.
Always contact a qualifi ed electrician to resolve wiring problems.
Always contact a qualifi ed electrician to resolve wiring problems.
Operate the Push Button on the GFCI Receptacle. If the GFCI circuit
Operate the Push Button on the GFCI Receptacle. If the GFCI circuit
does not trip, the receptacle is not operating properly.
To test the functionality of a Ground Fault Circuit Interrupter receptacle,
apply leads to the hot and ground terminals for 7 seconds.
•
If the GFCI receptacle is wired properly, power to the circuit
will go out and the ET50 will stop indicating voltage.
•
If the GFCI receptacle is wired improperly, power to the circuit
will remain and the ET50 will continue to indicate voltage.
To resolve an issue, contact a qualifi ed electrician.
Battery Replacement
Batteries are not required for visual voltage indication.
1.
Remove test leads from voltage source.
2.
Unscrew battery cover and replace 3xAAA batteries.