OPERATING INSTRUCTIONS
PLEASE SEE REVERSE SIDE.
CUSTOMER SERVICE
KLEIN TOOLS, INC.
450 Bond Street, Lincolnshire, IL 60069
1-800-553-4676
customerservice@kleintools.com
www.kleintools.com
*The Bluetooth® word mark and logos are registered trademarks owned by Bluetooth SIG, Inc. and any use of such marks by
Klein Tools, Inc. is under license.
RESET WIRELESS CONNECTION OR PAIRING WITH DIFFERENT DEVICES: Double-press Power Button 1 (tone sounds).
Repeat Pairing procedure with different devices.
PLAYING AUDIO: Use your device to control the speaker or use the built-in control buttons on the speaker.
Press Play/Pause/Talk button 3 to play or pause audio on your device.
Short-press the “-” 2 or “+” 4 button to adjust the speaker volume. A tone will sound when maximum volume is reached.
Volume may also be controlled from your audio device.
Long press the “-” 2 or “+” 4 button to skip backward or forward (respectively) during a song.
AUXILIARY AUDIO-IN: Connect one end of the auxiliary cable to the AUX jack 6 of the speaker, plug the other end of cable to
line-out or headphone jack of your device.
SPEAKERPHONE OPERATION:
When an incoming call occurs, playing music is muted & ring tone sounds. Short-press Play/Pause/Talk button 3 to answer
the call, or long-press to ignore.
To disconnect the call, short press the Play/Pause/Talk button 3 to hang up.
To redial last call, long press Play/Pause/Talk button 3 when speaker is playing music.
LOW BATTERY INDICATION: A continuous double-beep tone will sound when battery level drops to approximately 10%.
Speaker will automatically power off when the battery level is below 3%. Recharge speaker as soon as possible.
POSITIONING SPEAKER:
Make sure that front of speaker is not obstructed.
Stand speaker upright on a flat, level, stable surface.
Attach speaker to a metal surface via the magnet on the back of the unit 12. DO NOT mount to electrical equipment.
Mount speaker to any tripod or stand that uses a standard 1/4-20 threaded mounting screw, via the 1/4-20 mount 11 on the
bottom of the unit.
Mount speaker to the Klein Tools Lighted Tool Bag, Cat. No. 55431. To attach speaker to tool bag, first remove worklight
from bag by rotating counter-clockwise. Align tabs on mounting flange 13 on the back of the speaker with mounting hole on
bag and rotate clockwise to secure in place.
COMPLIANCE
FCC & IC COMPLIANCE
This device complies with part 15 of the FCC RULES and Industry Canada license-exempt RSS standard(s). Operation is
subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any
interference received,including interference that may cause undesired operation.
NOTE: The grantee is not responsible for any changes or modifications not expressly approved by the party responsible for
compliance. Such modifications could void the user’s authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC
Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be
To Next Page
Loading...