Title of this help project15
© 2003 Klein Instruments Corporation
To record data, as in Single White Point Spec, enter a serial number andmeasure the required points by
aiming the colorimeter appropriately and clicking the corrresponding "Measure Buttons" Then select the
second white point inspection buttton, change the display to the new white point, and measure the
required points by aiming the colorimeter appropriately and clicking the corrresponding "Measure
Buttons". After all buttons have been pressed for all Spec Selections, the "Record to DataBase" button
becomes enabled, and the data may be stored to the database (and optionally graphed with the Show
When the Report for a dual spec display is made, it appears as two pages of graphs, one page for each
6.3 Making and Printing Reports
It was shown in "Data Logging, Single White Point Spec" section how to log a reading. Once several
loggings have occured, the data can be accessed in the DataGraph window. To do this, press the
"Graphing" button in the "Data Logging" window.
To Next Page
Loading...
Need help?
General
