3
IMPORTANT SAFETY INSTRUCTIONS
When installing and using this electrical equipment, basic safety precautions should always be
followed
RISK OF ELECTRIC SHOCK.
Make sure your installation is connected to a ground hold.
This pump must be installed by a qualified technician.
A poor installation can pose a serious danger to pool users or others due to an
electric shock and can also damage property.
Always unplug the power before intervening on the pool pump.
Never open the inside of the drive engine enclosure
RISK OF ASPIRATION
The suction output is connected to a pump. It can suck up a lot of emptiness if it is
obstructed. Therefore, if only one exit is used, anyone obstructing that exit with a part
of their body can get stuck in it.
HYPERTHERMIC RISK
Water temperatures above 38 degrees Celsius can be hazardous to
health. Hyperthermia occurs when the body's internal temperature reaches a degree
above the normal body temperature of 37 degrees Celsius.
The effects of hyperthermia include:
- Ignorance of imminent danger.
- Failure to perceive danger
- Failure to recognize the need to leave the Spa or others.
- Physical inability to get out of the spa.
- Fetal damage in pregnant women.
- Unconsciousness leading to danger of drowning.
WARNING
This pump is for permanent use installed in ground or above-ground pools and can
also be used with hot tubs and spas if marked.
Do not use with above-ground pools that can be easily disassembled for storage.
Never tighten or loosen the screws while the pump is running.
Do not dry the pump. In case of drought, the mechanical seal will be damaged and
the pump will start to leak. Fill the pump with water before you start.
To Next Page
Loading...