1.
2.
3.
4.
5.
Pour a small drop of washing liquid and warm water into the Blender Jar and fill up to half of the
Maximum Capacity.
Securely attach the Centre Cap and Lid to the Blender.
Press the ‘Auto Cleaning’ button and the appliance will heat up to 70°C and then blend for 2 minutes.
Unplug the appliance, pour out the soapy water and rinse the Blender Jar under a tap.
Use a dry cloth to carefully clean the Driving Shaft Head and Blender Jar.
Do not soak the Blender in water or any other liquid to avoid damages.
Do not use metal wool, brushes, rough scrubbers or sharp-edged tools on the Blender to
avoid scratching.
Do not use metal wool or brush to wash the blade unit to avoid scratching.
Use only soft cloth when cleaning the motor unit and blade unit.
Do not put the Blender Jar into the dishwasher.
Do not rinse the Motor Base or the bottom of Blender Jar.
To ensure consistent and optimum performance clean the heating plate with a soft cloth after using.
Do not use sharp-edged tools to clean any burnt ingredients o of the Blender. Instead fill the
Blender Jar with warm water and let it sit for 2 hours. Then using a soft cleaning brush carefully
remove any residue.
For the best results, soak beans or rice for a few hours prior to using.
CLEANING
Note
Tips
WARM
TAP WA SH
DISH
WASHER
WIPE CLEAN
WITH WET
CLOTH
Auto Cleaning
To Next Page
Loading...