IMPORTANT: REVIEW ALL WARNINGS ON PAGES BEFORE PROCEEDING
Assembling the Appliance
1. Plug in Motor Base and place on a clean,
dry level surface such as a countertop or table.
2. Lower the Blender Jar onto the motor base.
3. Add ingredients, making sure to not exceed
the max fill lines on side of Blender Jar.
In COOK mode, DO NOT exceed the level
labelled “SOUP” in BLEND mode,
DO NOT exceed the level labeled “COLD”.
4. To install the lid on the Blender Jar, place the
Blender Lid tab to the right of the handle.
Press the Lid down until it is secure. Rotate Lid
clockwise so the Lid tab and the handle tab are
aligned.
5. Secure the Centre Cap by placing it down in
to the Lid and twisting clockwise until it clicks
in to place.
6. To remove the Lid from the Blender Jar,
rotate Lid counter clockwise out of the lock
potions and lift up.
NOTE: After heated programs, steam may
release as the Lid is removed. Keep hands on
the outer tabs and lift directly up.
HOW TO USE
Cold Line
(1200mL)
Soup Line
(800mL)
To Next Page
Loading...