KLEVA MEALiO - Troubleshooting Appliance Issues


HINTS & TIPS
What To Do If Appliance Does Not Work :
PROBLEMS CAUSES SOLUTIONS
Appliance does
not work.
Blender sensor position
does not match the handle
sensor position.
Place the lid securely on the Blender Jar
and turn clockwise until it cannot turn
anymore. Check that the Blender sensor
and Handle sensor positions match.
Appliance suddenly
stopped during use.
The motor has over heated
and the Overheat Protection
has activated and stopped
the appliance.
Unplug the Blender from the power socket
and wait 30 -45 minutes for the motor to
cool down before trying to use again.
Ingredients
overflowing.
Lid or Lid Cap has not
locked securely.
Check the Lid and Lid Cap and lock them
firmly.
Blade jammed.
Ingredients are too large
to blend.
Turn o and unplug the Blender from the
power socket. Carefully clean out the
ingredients that have jammed on the blades.
Display E01
Blender sensor position
does not match the Handle
sensor position.
Place the lid securely on the Blender Jar
and turn clockwise until it cannot turn
anymore. Check that the Blender sensor
and Handle sensor positions match.
Jug sensor is not aligned with
motor base sensor or
thermistor does not work.
Make small adjustments to the positioning
of the jug to re assure the alignment with
the motor base. If the display error still
persists please contact the Kleva Range®
customer service.
Display E03
Appliance is Overheating.
Turn o and unplug the Blender from the
power socket and remove the jug from the
base. Leave for a minimum of 30-45
minutes to cool down before trying to use
again.
Display E04
Device Protection activated
This appliance features a unique safety
system to prevent damage to the blender by
temporarily disabling the motor if it begins
to overheat. Turn o and unplug the Blender
from the power socket and leave for 30-45
minutes to cool down before trying to use
again. If the display error still persists
please contact the Kleva Range customer
service.
Display E05
Odd smell at the
beginning of first
Oil protection on motor,
this is normal.
Smell will disappear after a few uses.