EasyManuals Logo

Klima 500 User Manual

Default Icon
15 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #4 background imageLoading...
Page #4 background image
3. POINTS OF ATTENTION:
The cable is insulated and watertight and can be installed on Foil finished insulation
(Kingspan or Celotex) or existing concrete bases. The construction of the cable also allows
installation in wet spaces. The heating cable may never be installed under fixed objects
like wall units, kitchen units, baths, or showers and must be able to give off its warmth
unimpeded.
The power supply must be disconnected during installation. All installations must be wired
through a suitably rated MCB or RCCD when applicable. All installations in wet areas
must be wired through a dedicated RCCD in line with the thermostat. All connections must
be made by an approved Electrician in accordance with current IEE regulations.
The electrical heating cable is patented worldwide and fully conforms to the European
IEC 800 standards.
The cables capacity is 17W per meter at 230V. The invisible transition of the resistance
cable (heating section of the cable) to the power cable (cold connection part of the
cable) is indicated by the word "SPLICE" between two arrows. The 2 meter power cable
marked with stars: ******, may be extended.
THE HEATING CABLE CANNOT BE SHORTENED!!!! THE END SEAL CANNOT BE BROKEN!
This Klima Cable is a twin conductor (built in return cable) and has an extra aluminium
earth cladding to neutralise magnetic fields.
If multiple cables are installed in a space, they must be wired in parallel and a suitably
rated junction box may be incorporated so that only one power cable runs to the thermo-
stat. Maximum capacity of the thermostat is 16 Amperes. If fitting more than one cable
set and the combined area length exceeds 3400 watts, a suitably rated Contactor will
have to be fitted. The thermostat may only be installed by a qualified electrician.
The Klima Cable can be used under various floor finishes - Tile, Marble, Slate, Wood,
Laminate, Vinyl and Carpet. (Tog rate of carpet and underlay should not exceed 2.5).
If using underneath a wooden floor or carpet please contact your flooring supplier.
4

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Klima 500 and is the answer not in the manual?

Klima 500 Specifications

General IconGeneral
BrandKlima
Model500
CategoryFloor Heating Systems
LanguageEnglish