OPERATION
- ON/OFF:
The control unit is switched on/off by pressing and holding the P1 (ON/OFF).
The L5 LED turns on to indicate the OFF status.
- SAFETY function:
If the temperature detected by the H2O PROBE exceeds the value of the Safety Thermostat, this forces the activation
of the PUMP.
- ALARM function:
If the temperature detected by the H2O PROBE exceeds the value of the Alarm Thermostat, this activates the acoustic
and visual signal.
SILENCE: pressing any button deactivates the acoustic signal for 5 minutes.
- FROST PROTECTION function:
If the temperature detected by the H2O PROBE goes below the value of the ANTIFREEZE Thermostat, this activates
the timed PUMP outlet.
The relative L1 LED turns on and ICE starts flashing on the display.
- PUMP ANTI-LOCKING programme:
In the event of inactivity of the PUMP outlet for longer than the ANTILOCKING Timer, this activates the outlet of the
PUMP.
The relative L1 LED turns on and bLP appears on the display.
- STANDBY function:
If the device is OFF and in SECURE mode, the device automatically positions itself to ON status.
- PUMP TEST function:
Pressing and holding the P3 key activates the PUMP outlet until the button is released. The display will show tSt.
- LEVEL SWITCH function:
The closure of the input closure determines the activation of the L4 LED.
- OUTLET function:
§ PUMP ON: for temperatures above the PUMP thermostat setting
for temperatures above the ALARM thermostat setting
for temperatures below the ANTIFREEZE thermostat setting
§ VALVE ON: for a temperature above the VALVE Thermostat temperature
§ AUX ON: for a temperature above the AUX Thermostat temperature
§ SERV ON: for temperatures above the Thermostat setting
- DHW function:
By holding down the P2 (-) and P3 (+) buttons at the same time it is possible to activate the DHW function. At this point,
while the L6 LED flashes, simply set the time (in minutes) for which you want to have all the heat burned for the
production of domestic hot water. This function turns the pump off for the set time in minutes. When this function is
active, the pump will turn on only if the safety temperature of 85 ° C is reached. It is possible to deactivate this function
by holding down the P2 (-) and P3 (+) buttons again.
- OVEN LIGHT function
The light inside the oven light can be switched on by pressing the P4 (Set) button for 5 seconds. At this point, while the
L8 LED is flashing, set the time (in minutes) for the time chosen for the light to remain on. The oven light can be
switched off before this time by pressing and holding the P4 (Set) button once again.
To Next Page