Page 17 of 28
INSTALLING THE BIT
CAUTION! Wear heavy-duty work gloves to provide protection when inserting and removing drill bits.
Drill bits become very hot during use. Do not remove a drill bit until it has cooled.
1. Loosen the Chuck with the Chuck Key until the jaws of the drill are opened enough to fit the drill bit.
2. Insert the drill bit approximately 1″ into the jaws of the Chuck, ensuring that the jaws do not touch
the flutes of the bit.
3. Hand tightens the Chuck until the bit is held securely in place. Confirm that the bit is centered
between the Chuck jaws.
4. Use the Chuck Key to tighten the Chuck.
·Insert the tip of the Chuck Key into a hole on the side of the Chuck so that the teeth on the Key
engage the gear on the Chuck. Use the Key to tighten the Chuck securely and remove the Key.
NOTICE: Use sharp bits. Dull, bent, or damaged bits will cause stress on the drill and/or break.
USING THE LED LAMP
1. Flip the LED Lamp Power Switch (73) to turn the LED Lamp (72) on.
2. Use the Lamp's built-in goose-neck to move it to a position where it illuminates the workpiece in
the area where it is being drilled.
3. Turn off the Lamp after use. Move the Lamp away from the Chuck before removing the drill bit and
cleaning the tool.
To Next Page
Loading...
