5 Attach Cover and Guide Bar.
Attach Handle.
Ensure the Handle is fully inserted.
If not inserted fully, Handle may detach while operating and cause injury.
4 Lift the handle to raise Roller Arm.
Roller Arm ② will not move if the Positioning Arm ① is not
in the highest position.
Raise Roller Arm.
Thickness Adjustment Knobs
③ will go into Positioning Hole
and fasten Roller Arm.
3 Raise Positioning Arm to the highest position.
Raise to the highest
position.
Roller Arm
Positioning Arm
2 Remove Cover, Handle, and Guide Bar.
1 Place on a stable surface.
The machine may move when placed on an unstable surface.
(Please use a commercial Anti-slipping mat if the machine moves while in use.)
SETUP
②
①
③
①
To Next Page
Loading...